Ultra Bond 40cps Crystal Quartz Windshield Repair Resin.

1/4 Liter of 108% New Windshield Glass Strength

NEW as of May 2026 Crystal Quartz Resin. At Ultra Bond we altered the formula and were abel to make stone-breaks disappear and eliminate curing under pressure (CUP). We were able to do that and it scored 100%+ not cured under pressure. Not curing under pressure (CUP) normally can reverse the wicking of the glass that took place and with low viscosity (under 40-45cps ) there will be shrinkage.  With the Wonder Bar Tools, both the 2-bar bridge and one-bar with the 3-inch suction cup and the Black Tool have pure compression. This mean the break and all the legs are flexed open at once symmetrically. When the flex is released (we call the "Flex and Release Method")  with the resin under pressure there is a forceful wicking of the glass and an overfill of the legs and bullseye. Doing this twice during the repair as shown in our videos with the new formula reached 100% + new laminated glass strength cured under pressure and not cured under pressure (CUP).

 

ROLAGS Mechanical Strength Test by 3-Point Bend Test after Thermal Cycling.


Scores by tool and curing light:


NOTE: With the Single Wonder Bar Tool with the 3-inch suction cup, Flex and Release by pushing on the end of the bar with your thumb and then release when the legs fill. Do this twice during the repair as shown with the videos of the Wonder Bar Bridge and Black Tool as well as the usual one minute vacuum during the repair to degas the resin.


TEST SCORES:

NEW 40 Resin 

  • Single Wonder Bar with the 3-inch suction cup, no CUP with 2 Bond Wands side by side ,remained intact =over 100%
  • Single Wonder Bar with the 3-inch suction cup, not cured under pressure (CUP) with 2 Bond Wands side by side =107%
  • Single Wonder Bar with the 3-inch suction cup, not cured under pressure (CUP) with 2 Bond Wands side by side =111%
  • Singe Wonder Bar with the 3-inch suction cup, not cured under pressure (CUP) with 2 Bond Wands side by side,  remained intact =100%+


Wonder Bar Bridge (2 Bar Tool) Cured Under Pressure is 108% New Laminated Glass Strength.


50 resin - Single Wonder Bar with the 3-inch suction cup, not cured under pressure (CUP) with 2 Bond Wands side by side =108%


NOTE: What can cause a bubble in the pit when NOT curing under pressure?


(a) The way you remove the tool and (b) the way you pit fill.


There is no shrinkage with this resin.
1. Not flexing and releasing TWICE which causes the overfill so the resin comes out the pit when you are done and remove the tool. However when you are done and removing the tool you are doing the second release of the 2nd flex and release cycle on the break and glass while the resin is under piston pressure. With the Wonder Bar Flexing Bridge, 1st release the flex bolt off the glass, then slowly loosen the cylinder until all the flex on the break and glass is released. The cylinder should be loose, to the point where the resin could leak out. Then push the tool off the impact. The pit should be filled with resin.
2. Then level the resin in the pit with a razor blade. Do not wipe it out. Put pit filler /2400 or 1600 on top of the resin in the pit and roll the tab on. Then cure.
3. Also sometime during the first cycle degas the resin by doing a 1-2 minute vacuum. This is while in the 1st flex mode before you do the release of the 1st cycle.


This is the 40 CPS Stone Chip windshield repair resin. The 1/4 liter 40 cps bottle will get you three years worth of windshield repair resin.